J2607A Technical Specifications
HP 10 Base Transceiver Module
J2607A
HP Transceiver
HP EtherTwist 10Mbps 10Base-T Copper Mode
Twisted-Pair RJ-45 Connector
Transceiver Module.
J2607A – HP EtherTwist 10Mbps 10Base-T Copper Mode Twisted-Pair RJ-45 Connector Transceiver Module.
J2607A
HP Transceiver
HP EtherTwist 10Mbps 10Base-T Copper Mode
Twisted-Pair RJ-45 Connector
Transceiver Module.
The Cisco ONS 2.5-Gbps fixed-rate OC-48/STM-16 DWDM optics provide both transmit and receive optical interfaces in a single SFP footprint pluggable into any of the four ASAP 4-PIO slots. Each port interface operates at the standard SONET/SDH (Telcordia GR-253-CORE, ITU G.703 and ITU-T G.694.1) 2488.32-Mbps bit rate. The Cisco ONS 2.5-Gbps fixed-rate OC-48/STM-16 DWDM SFP uses a duplex LC connector on the SFP faceplate that is routed through a fiber tray on to the cable-routing module for termination. The Cisco ONS 2.5-Gbps fixed-rate DWDM SFP carries both concatenated payloads of STS-3c/VC-4, STS-6c/VC-4-2c, STS-9c/VC-4-3c, STS-12c/VC-4-4c, STS-24c/VC-4-8c, and STS-48c/VC-4-16c and nonconcatenated payloads on an STS-1 basis. In SONET mode, each optical port can be provisioned as STM-16 to enable the tunneling of SDH payloads in the form of STS-Nc concatenated payload over a SONET network. This helps enable North American service providers to transport SDH traffic from international cable landing points to customer sites. When operated within the outlined specifications (refer to Table 5), each port interface transports a 2.5-Gbps signal with a minimum BER of 10E-12. The Cisco ONS 2.5-Gbps fixed-rate OC-48/STM-16 DWDM SFP provides 32 wavelengths in the ITU-T G.694.1 C-Band channel plan.
AFCT-57D5ATPZ-H1 HP – 8GB Long Wave B-Series 10KM Fibre Channel 1 Pack Sfp+ Transceiver.
J4834A HP ProCurve 100/1000BaseTX Transceiver Module.
AG870A HP – MDS 9000 10GB Fibre Channel X2 Copper Transceiver.
0231A72X- HP X135 – XFP Transceiver Module – 10GBase-Er – Lc – Plug-In Module.
The industry-standard Cisco Small Form-Factor Pluggable (SFP) Gigabit Interface Converter is a hot-swappable input/output device that plugs into a Gigabit Ethernet port or slot, linking the port with the network . SFPs can be used and interchanged on a wide variety of Cisco products and can be intermixed in combinations of 1000BASE-T, 1000BASE-SX, 1000BASE-LX/LH, 1000BASE-EX, 1000BASE-ZX, or 1000BASE-BX10-D/U on a port-by-port basis.
J9142A HP ProCurve X112 1Gbps 1000Base-BX-D Single-mode Fiber 20km 1490nmTx/1310nmRx LC Connector SFP Transceiver Module
E7Y42A HP Brocade Xbr-000172 8-Pack 8GB 10km Fibre Channel Long Wave Length Sfp+ Transceiver.
0231A0LQ HP X120 1GB Sfp Lc Sx Transceiver.
AE379-63001 HP 4GB Sw Fc Sfp Transceiver 4 Pack.
AFCT-57F5ATPZ-H1 HP 16GB SFP+ Short Wave 1-Pack Commercial Transceiver.
The Cisco 10GBASE Dense Wavelength-Division Multiplexing (DWDM) SFP+ modules allow enterprises and service providers to provide scalable and easy-to-deploy 10-Gigabit LAN, WAN, and optical transport network (OTN) services in their networks.
Get access to your Orders, Wishlist and Recommendations.
Shopping cart is empty!
![]()


There are no reviews yet.